Metrology and Calibration Flight keeps Hill AFB calibrated
(Right to left) Jay Hudson, Metrology and Calibration Flight technician, and Richard Thompson, MCF summer intern, and Brian Wilson, MCF dimensional work lead, check tolerances on a jig fixture used for building A-10 fuselage sections. Machine inspections and calibrations are accomplished on thousands of machines throughout the installation each year by personnel in the 809th Maintenance Support Squadron. (U.S. Air Force photo by Todd Cromar)
PHOTO BY:
Todd Cromar
VIRIN:
230725-F-LS255-1003.JPG
FULL SIZE:
3.89 MB
CAMERA
NIKON D5
LENS
N/A
APERTURE
63/10
SHUTTERSPEED
10/1600
ISO
1600
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.